One cable slipping off its drum groove is enough to jam a door mid-cycle or send a panel crashing at an angle. We fix the cable and check why it slipped in the first place.
A single-cable fix often means a second failure soon after. We explain the pair-replacement logic upfront.
A cable can slip its groove repeatedly if the drum itself is damaged, which we check before calling the job done.
This repair sits close to stored spring energy, which is exactly why licensed handling matters here too.
We carry the common cable lengths and gauges for most residential door sizes.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
We replace the snapped cable and its pair, then verify even tension across both sides.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
A cable that's jumped its drum groove can jam the door mid-cycle. We reset it correctly and check for the underlying cause.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Technicians carry standard cable gauges and lengths for most residential doors.
We check both cables and the drums together, then quote a flat price covering the full fix.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
One side losing tension while the other holds is the classic sign of a single cable or spring failure.
Both cables typically get replaced together to avoid a near-term repeat call.
Yes, a door hanging on a single cable or spring can drop unexpectedly and should not be operated until repaired.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
A snapped-cable call usually resolves in under two hours on-site.
Same-day dispatch, upfront pricing, and a written warranty on every visit.
☎ Call +1-831-293-1591From one side of Englewood to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Englewood, TN